en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Headlamp Aim Adjustment (Canada)

  1. Verify that headlamp aim inspection conditions are met. See Headlamp Aim Inspection Conditions.

  2. Position the vehicle on a level surface with the nose approximately 9 ft (2.7 m) from a wall 1.

  3. Press the Engine Start button twice to enter Accessory Mode, then pull the turn signal lever rearward (as if to activate the high beams).

    IMPORTANT
    If the engine was last powered-off with the high beams still on, then pulling the turn signal lever in Accessory Mode will reactivate the high beams. Verify that the LOW BEAM lights (not high beams) are activated to perform headlamp aim adjustment.

  4. Observe the headlight beam display on the wall. The beam displays at two levels, higher at the right side and lower at the left side.

  5. Measure from the floor to the lower beam display at the left side. When the beam is properly adjusted, this measurement should be 21.5 in (54.6 cm).

  6. To adjust a headlight beam, open the hood and turn the two upper headlamp screws 2 simultaneously and equally. Turning the adjustment screws in tandem keeps the beam pointed straight, so as not to skew left or right.

  • Clockwise adjustment raises the beam

  • Counter-clockwise adjustment lowers the beam

Parent topic: Lights