en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Error Codes

The error screen displays only when the MIL, AWL, EPS, or ABS lamp is on or when it goes on and off during one ignition cycle. Error codes are not stored. When the key is turned OFF, the code and message is lost, but will reappear if the fault reoccurs after restarting the engine.

If an error lamp illuminates, retrieve the active error codes from the display.

  • 1 Failure Mode Indicator (FMI)
  • 2 Suspect Parameter Number (SPN)
  • 3 Code Count

  1. Press and hold the MODE button to enter the settings menu.

  2. Press either toggle button to cycle to the “DIAGCODE” option. Press MODE to select.

  3. More than one diagnostic code may be present. Press the toggle UP button to see if more codes are present. Press MODE to select a code.

    NOTICE
    If the displayed code is an engine fault code, the CHECK ENGINE lamp will blink. If the displayed code is an EPS fault code, the EPS lamp will blink.

  4. Record the three (3) numbers displayed.

  5. Press MODE to exit to the settings menu.

Parent topic: Rider Information Center