en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Passcodes Using The Ride Command Display

If the vehicle is equipped with a Ride Command display, it is used to enter/edit passcodes if the key fob is not within range. Refer to the Display Screen section of this manual for more details on how to operate.

Passcode Entry - Ride Command Display

If the key fob is not found by the Vehicle Control Module (VCM), the Ride Command display will prompt the operator to enter a passcode to unlock vehicle operation.

Use the number pad to enter your user passcode or the master passcode.

NOTICE
If a user passcode has not been set, the master passcode must be entered. Inquire with your authorized dealer for master passcode entry.

If the entry is correct, the vehicle can be operated as normal.

If the entry is incorrect, the Ride Command screen will display “Incorrect Passcode. Try again.”

If over five unsuccessful attempts are made, the Ride Command screen will display “Too many passcode attempts. System will shut down.” This will require an ignition cycle before further attempts can be made.

Passcode Change - Ride Command Display

Perform the following steps to change the vehicle passcode.

NOTICE
If a user passcode has not already been set, the master passcode must be entered.

  1. Go to ‘Settings’ by touching the Slingshot logo at the top of the screen and then touching the ALL SETTINGS button in the lower-right corner.

  2. Touch the ‘Vehicle’ tab on the left side, and then the “Passcode Unlock” line.

  3. Touch the “Change Passcode” button.

  4. Follow the screen prompts to edit the vehicle passcode.

If new passcode verification is successful, the Ride Command screen will display “New code accepted”. The new user passcode may now be used to unlock vehicle operation.

If the new passcode verification is unsuccessful, the Ride Command screen will display “Enter Current Code” and you will need to re-enter the new passcode.

If the second verification attempt is unsuccessful, the Ride Command screen will display “New codes did not match”, and will prompt you to enter and verify a new passcode again.

Parent topic: Security System (if equipped)