en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Bleeding the Cooling System

The cooling system is a self bleeding system.

CAUTION

Cooling system under pressure. Steam and hot liquids will cause burns to your skin. Never bleed the cooling system or remove the pressure cap when the engine is warm or hot. Wear eye protection when servicing the cooling system.

NOTICE

Pressure cap rated at 13 PSI (0.9 BAR). Use of a non-standard pressure cap will not allow the recovery system to function properly.

CAUTION

Perform this procedure in a well-ventilated area. Use the recommended 50/50 Extended-Life Antifreeze.

  1. Remove right side panel.

  2. Fill the coolant bottle to the COLD FILL mark.

  3. Install the coolant bottle cap to the half lock position. Do not tighten to the fully seated position.

  4. Lock the parking brake.

  5. Start the engine and allow it to run at a fast idle for several minutes, until the tunnel coolers are warm to the touch.

    CAUTION

    Keep the coolant level in the coolant bottle at or near the COLD FILL mark when engine is running. The engine may suck the coolant down quickly which my require coolant to be added a few times to stabilize the coolant level.

  6. When all tunnel cooler extrusions are warm to the touch, stop the engine.

  7. Allow the engine and cooling system to cool.

  8. Fill the coolant bottle to the COLD FILL mark. Reinstall the bottle cap securely.

  9. Reinstall the right side panel.

Parent topic: Cooling System