Indicator Lamps
Lamp | Indicates | Condition |
---|---|---|
![]() |
High Beam |
The headlight switch is set to high beam. This indicator will flash if there is a problem with the low or high beam light. |
![]() |
Chassis Fault |
The alert symbol illuminates when a chassis fault occurs. This alert symbol will also illuminate if there is a low battery charge, low oil pressure, low fuel level, or if the sidestand is down. This light will be accompanied by the MFD showing: S-StND (Sidestand), battery icon (Low Battery Voltage), LoWOIL (Low Oil), or flashing fuel bars (Low Fuel Level). |
![]() |
Turn Signals |
One arrow flashes when the corresponding turn signal is activated. Both arrows flash when the hazard signal is activated. If there is a problem in the signal system, the lamps will flash at twice the normal rate. |
![]() |
ABS Not Activated |
The indicator remains on until the anti-lock system activates, which occurs when vehicle speed exceeds 6 mph (10 kph). When the lamp is illuminated, the anti-lock brakes will not activate, but the conventional brake system will continue to operate normally. The lamp will also illuminate if an ABS fault is detected. |
![]() |
Neutral |
The transmission is in neutral and the power switch is ON. |
![]() |
Traction Control |
The traction control fault indicator remains on until the traction control system activates, which occurs when vehicle speed exceeds 6 mph (10 kph). This lamp flashes when traction control is actively limiting rear wheel slip. The lamp illuminates and remains on when traction control is disabled. The traction control fault indicator illuminates when the traction control system has experienced abnormal operation and will remain on as long as the fault condition exists. |
![]() |
Check Engine |
If this lamp illuminates while the engine is running, see your dealer promptly. The light will remain on if the tilt sensor shuts down the engine. If abnormal sensor or engine operation is detected the light will remain on as long as the fault condition exists. Retrieve the error codes for diagnosis. If a misfire is detected, the check engine lamp will begin to flash and fuel will be cut to the affected cylinder(s). See Misfire Detection. |
![]() |
Engine Overheat |
The engine overheat light will illuminate when the engine temperature exceeds normal operating temperature. |
![]() |
Vehicle Speed |
When standard mode is selected, speed displays in miles per hour. |
![]() |
When metric mode is selected, speed displays in kilometers per hour. |