en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Headlight Aim Inspection

Adjust headlight aim when there is a change in load (rider, cargo, accessories, etc.) and/or after suspension adjustment.

  1. Verify that tire pressure is at specification.

  2. Verify that rear suspension ride height (preload) is at specification.

  3. Position the motorcycle on a level surface with the headlight 32 ft (10 m) from a wall.

  4. With the rider, passenger, and luggage (if applicable) on board, bring the motorcycle to the fully upright position.

  5. Start the engine and switch the headlight to low beam. Observe the headlight aim on the wall.

  6. Make any necessary adjustments to headlight aim, per the diagram table.

  7. After adjusting the vertical aim using the low beam, switch to high beam and make sure the area of highest intensity is directly in front of the motorcycle. If not, adjust to the right or left as needed.

NUMBER DESCRIPTION
1 LED Headlights: 4 in (10 cm) to top cut-off of beam
2 Measure distance = 32.8 ft (10 m)
3 Headlight Center
Parent topic: Headlight